Mist Pump Box Factory introduces the related knowledge of spray pump:
1. Fan shape, round shape, and spray shape, generally these three.
2. The spray pump is mainly composed of crankcase, return steel sleeve assembly, pump head assembly, etc. A safety valve is installed on one side of the discharge chamber of the pump head, and an overflow valve is installed on the other side. A vent hole is provided above the liquid inlet cavity cover to exhaust the air in the cavity; an antifreeze liquid discharge hole is provided under the liquid inlet cavity cover to drain the liquid in the liquid cavity.
The pump head assembly is the hydraulic end of the pump. There are three sets of suction valves in the lower part of the pump head, and three sets of discharge valves in the upper part. The glands at the ends of the three high-pressure chambers are all provided with vent holes, which are set up for exhausting the air in each chamber when the pump is turned on or during work. The high-pressure steel sleeve assembly, the plunger is sealed with three rectangular sealing rings.
3. The safety valve is the function of safely releasing liquid when the pump exceeds the set pressure.
Through the above introduction, Rubber Rings Factory hopes that you can simply refer to the content of this article in future use.
1. Fan shape, round shape, and spray shape, generally these three.
2. The spray pump is mainly composed of crankcase, return steel sleeve assembly, pump head assembly, etc. A safety valve is installed on one side of the discharge chamber of the pump head, and an overflow valve is installed on the other side. A vent hole is provided above the liquid inlet cavity cover to exhaust the air in the cavity; an antifreeze liquid discharge hole is provided under the liquid inlet cavity cover to drain the liquid in the liquid cavity.
The pump head assembly is the hydraulic end of the pump. There are three sets of suction valves in the lower part of the pump head, and three sets of discharge valves in the upper part. The glands at the ends of the three high-pressure chambers are all provided with vent holes, which are set up for exhausting the air in each chamber when the pump is turned on or during work. The high-pressure steel sleeve assembly, the plunger is sealed with three rectangular sealing rings.
3. The safety valve is the function of safely releasing liquid when the pump exceeds the set pressure.
Through the above introduction, Rubber Rings Factory hopes that you can simply refer to the content of this article in future use.
コメント